R E C E I V E R

RECEIVER D6003B

The Datek D6003B field bus receiver has been designed to operate industrial and mobile applications safely. The receiver is suitable for all kinds of applications where the Profibus DP-V1 or various types of CAN-bus are used. Field bus technology involves the serial transmission of information to a PLC, as opposed to parallel transmission using separate outputs.

Comprehensive safety
Datek uses synchronous data transmis- sion, which means that each bit of data is checked very carefully. Even the smallest deviation from the norm is detected, and then the entire data packet that has been received is rejected. Each system has a unique ID code. If the transmitter’s ID code does not match the receiver’s, radio communication will never be established

Both the protocol and its checksum are digitally verified by dual processors using different software. This provides what is known as a redundancy check.
If the processors interpret the protocol differently, they immediately shut down all outputs. Such safety features as digitally verified transmission and redundancy checking are just two of the innovations which Datek has pioneered in the area of radio remote control. Since its founding in 1979 Datek has focused on developing safe radio remote controls, something we still do and will continue to do!

Radio transmission
The receiver’s frequency is adjusted to the required frequency band. For frequency-shift transmitters, the receiver scans the frequency band until it finds the relevant transmitter with the correct ID code and protocol.

  • Safe control of industrial and mobile applications
  • Communicates with the field bus variants Profibus DP-V1 and various types of CAN-bus
  • Can be customised for various applications and according to preference
  • Easy to install and maintain
  • The use of a unique digital protocol and verification by double processors ensures safety
  • Designed for challenging environments and reliable operation. The receiver complies with protection class IP65 and is resistant to chemicals, cold, heat and humidity

Feedback
The receivers in this series can be provided with two-way communication. Feedback to the transmitter unit is obtained through semi-duplex, which means that only one frequency is utilised for both control signals to the receiver and feedback data. This is advantageous if availability of frequencies is limited, as you are only taking up one frequency instead of two.

Enclosure
The receiver comes in a robust fibreglass enclosure which complies with protection class IP65.

Recommended transmitters
• D2801 MIDI
• D2801 MIDI Extended
• D2012 Hand-Held Transmitter

GENERAL INFORMATION
Dimensions220 x 120 x 90 mm
Temperature range-25° – 70°C
Protection classIP65
RADIO TRANSMISSION
Frequency406 - 472 MHz
POWER SUPPLY
Supply voltage24 VDC
FIELD BUSSES
Datek CAN
CANopen
Sauer-Danfoss +1
OEM adjustments
Profibus DP-V1
OUTPUTS
Digital outputs7
Field busLimited by the transmitter
FEEDBACK
Digital inputs6
Field busAnalogue/Digital
Alarm messages65 536

<h3>DOWNLOADS</h3>